Accessory DIY Power Plug Adapter Kit

Fits non-ABS models only 2005 to 2014. 

DIY version of the Power Plug Kit for the do-it-yourself types that don't mind drilling into your existing black plastic left cover (above the glove box) on your GT, GTS, GTV, or Super, or put it anywhere you think it will fit.. 

Power GPS's, charge cell phones, tablets, and maybe even a laptop. Most anything up to 5amp that can use a 12 volt power supply with the standard cigarette lighter type adapter plug.

This kit includes the following part #s: 
PP1
PP2
PP3

You will need a SPLITTER if you are planning on installing two electrical accessories such as our LED kit, power plug, alarm, horn cover LED, etc. 

Very quick and easy install provided you can drill a 7/8" diameter hole. See instructions below:

Instructions for installing power source in existing cover:

1. Remove left hand side cover aka "knee pad"
2. Drill a 7/8" diameter hole in the center of the lower portion of the cover. **a "uni-bit©" brand stepped drill bit works best**
3. Thread both pieces of the powerplug onto the cover. Remember to install the black plastic cap.
4. Install the red wire in the harness you select to the brass connector and the black wire to the silver connector
5. Connect the large white connector on the other end of the adapter harness to the mating alarm connector in the scooter.

You will need an Alarm Interface Adapter if you are planning on installing this kit on a GTS/Super 300 2015 and newer with ABS.